1212 Weigh Scale This board is
the latest version of a Weigh Scale.
It is the micro controller for a plastic
blending
system. The current version of this board
uses a Freescale 9S12 processor as well as
an ARM processor. It has a switching power
supply. It has USB as well as Ethernet capabilities.
The
firmware
can
be
updated
simply with a flash drive. The opposite side
has a VFD display.
6811 Weigh Scale This is a legacy
version of a Weigh Scale. It is the micro
controller for
a plastic
blending
system. This version of this board
uses a ROM and RAM for its program.
MGF A Gravitational
Feeder. This board has a backlit LCD display,
an SD Card reader,
USB and Ethernet ports. Firmware updates
can be done from an SD Card or from a USB drive.
Water Basin This board goes in a portable triage sink.
It controls heater elements, water pump, foot petal switches, and reads the temperature
of the water being dispensed.
I/O board This is a generic input / output board
called an I/O board.
RTD board This is a RTD board. It is a striped down
version of the I/O board. It is used as a
temperature sensor with another product we
manufacture.
GVL or Basic
Loader (Front and back)
This runs a vacuum loading system. It has
alarm lights and beepers all built into the
board. It connects to a Pendant via the coax
connector on the board for extended settings
and a display.
GVL or Basic
Loader Pendant (Front and back)
This connects to a GVL or Basic Loader via
a coax connector (soldered to this board
after it is mounted in its box). The coax
wire provides power to this board as well
as communications.
Modular Clear
Vu loader board This is a current
version of a Clear Vu loader board. This
is part
of a vacuum
loading system for plastics.
Clear Vu loader board This is a legacy
Clear Vu loader board. This is part of a
vacuum
loading system for plastics.
Digital Pot board This is a Digital Pot board. This board
uses an optical encoder for user input, and
has a digital display to indicate settings
to the user. It communicates to another product
we manufacture, and sends out a dc voltage
to yet another product.
Dryer board This is a Dryer board. It is the micro
controller for a plastic drying system. This
board has capability of firmware (flash memory)
updates by the end-user. This can be accomplished
with either a PC, a Palm Pilot, or with a
flash memory card that we manufacture.
Flash card This is a Flash card. This is used to update
firmware on other products.
Loss In Weight board This is a Loss In Weight board. It takes
a setting from a digital pot board, and controls
the speed of an extruder to adjust the amount
of through-put of plastic being dispensed.
MLAN / Dongle board This is an MLAN / Dongle board. It is a
proprietary communications board and dongle
board for one of our customers.
Copy Vender board This is a Copy Vender board. This board
was re-engineered for a company that had
a very old, through-hole design. It is used
in vending machines with card scanners to
purchase products with a swipe card. They
are also used as stand alone devices to re-charge
cards.
Pump / Extruder board This is a Pump / Extruder board. This is
a board that powers a motor as a peristaltic
pump. It can be set to run at a specific
speed, for a certain length of time, or controlled
from an outside signal.
Thumbwheel board This is a Thumbwheel board. Though it is
not apparent on the photo, the back side
of this board has surface mount parts on
it. This board is used as an input to a few
products for one of our customers.
